MSLON Size 5 Football

The Laws allow 0.6 to 1.1 bar - 8.5 to 15.6 psi - at sea level, and most manufacturers recommend the middle of that, around 0.8 to 1.0 bar or 11.6 to 14.5 psi. The target is usually printed next to the valve, and that figure beats any general advice. Inflate to the lower end if the ball will sit in the sun, because heat raises the pressure.

Because people pump until the ball feels right rather than using a gauge, and an electric pump will happily run past the correct pressure. A hard ball is not a better ball - it loses the give that lets you control it, it stings the foot and the head, and the constant tension stretches the bladder and pulls the seams apart. An over-inflated ball ages in weeks rather than seasons.

There are three. FIFA Basic - previously called IMS, International Match Standard - is the entry-level mark. FIFA Quality is a more demanding set of tolerances. FIFA Quality Pro is the highest, with the tightest tolerances on roundness, rebound, water absorption and shape retention. All three mean a ball was independently laboratory tested and passed. They are not the same standard, and a ball carrying the entry mark should never be described as Quality Pro.

Yes, and it is a real buying decision. Latex gives a livelier, softer feel and is what better match balls use, but it leaks noticeably faster and needs topping up before most sessions. Butyl holds air far longer and needs less attention, at the cost of feeling slightly less responsive. Neither is wrong - it depends on whether you want feel or convenience.

A size 5 football is 68 to 70 cm in circumference and 410 to 450 g at the start of a match - the senior ball, for ages 13 and up. A size 5 rugby ball is a different thing entirely: 280 to 300 mm long, 740 to 770 mm long circumference, 410 to 460 g, and it takes only 9.5 to 10 psi. Do not inflate a rugby ball to football pressure.

Wet the needle before you put it in - a drop of water, glycerine or valve oil is enough. A dry needle tears the rubber valve as it goes in, and a torn valve means a ball that will not hold air and cannot be repaired. This is the single commonest way people ruin a new ball.

Deflate it slightly if it is going into storage for a long time, so the bladder and seams are not under constant tension. Wipe mud off rather than leaving it to dry on, because grit works into the seams. Keep it out of prolonged sun, and never leave it in a car boot. Check the pressure before every session rather than once a month.

Yes. We deliver across Dar es Salaam and send nationwide to Arusha, Moshi, Mwanza, Dodoma, Zanzibar and beyond by courier. Call or WhatsApp us if you need a same-day drop in the city.