Win.Max Jet-Aircraft Silver Steel Tip Darts Set - 23g

If a lighter dart feels twitchy or you struggle to keep a consistent line, yes. A slightly heavier dart carries its trajectory better against an imperfect release. The trade-off is a marginally more arcing flight. Neither is better - it is about which suits your action.

We are not claiming that. WIN.MAX publish no barrel material for the Jet-Aircraft, and the name refers to the styling, not the alloy. If you want a confirmed 90 percent tungsten barrel, ask us what we have.

Steel tip darts have a metal point and go into a sisal bristle board. Soft tip darts have a flexible plastic point and go into an electronic board. Never throw steel tips at an electronic board: the point punches through the plastic segments and can wreck the sensors underneath, and that is not repairable. Soft tips on a bristle board simply bounce out.

It is the proportion of tungsten by weight in the barrel alloy - the rest is a binder such as nickel, because pure tungsten is too brittle to machine. Tungsten is more than twice as dense as brass, so a higher percentage means a physically slimmer barrel at the same weight. Slimmer barrels take up less room in a treble bed, which is what lets three darts group in one segment.

2BA is the standard dart thread - 4.7 mm major diameter - and virtually every modern barrel, shaft and point uses it. The older alternative is a 1/4 inch thread, noticeably fatter and coarser, found on some cheap brass and house darts. They are not interchangeable and forcing one into the other strips the thread. Flights are not threaded at all, so any standard-shape flight fits any standard-shape shaft.

You are conditioning the point, not making it pointy. Roll the tip on the stone at a shallow angle, turning the dart as you go, until the burrs and flat spots from hitting wires are gone - ten or fifteen seconds is plenty. Leave it smooth and slightly rounded. A needle point is worse in every way: it skids off wires and bounces out, and it cuts sisal fibres instead of parting them, which puts permanent holes in the board.

The bullseye goes 1.73 m from the floor, and the throwing line sits 2.37 m horizontally from the face of the board - measured to the board face, not the wall, because a board with a surround stands proud of it. Cross-check with the diagonal: 2.93 m from the centre of the bull to the back of the oche. If the diagonal does not match, one of your other two measurements is wrong.

Yes. We deliver across Dar es Salaam and send nationwide to Arusha, Moshi, Mwanza, Dodoma, Zanzibar and beyond by courier. Call or WhatsApp us if you need a same-day drop in the city.